89 - 94 1.0L Specifications for Geo Metro
Model : GEO, Metro Category : Misc
... in.(89-91) 151.4 in.(92-94) Width: 62.7 in. Height: 53.5 in. Track (front/rear): 53.7/52.8 in. Curb Weight(lbs): 1,694 Convertible: Wheelbase: 89.2 in. Length: 147.4 in. Width: 62.7 in. Height: 52.0 in. Track (front/rear): 53.7/52.8 in. Curb Weight(lbs): 1,753 Interior Dimensions Hatchback Coupe: Head Room F/R: 37.8/36.5 in. Shoulder Room F/R: 51.6/50.5 in. Hip Room F/R: 51.1/42.5 in. Leg ... (more)
Posted : 3 June 2005  
 
DIY 2K Metro/Swift Steel Braided Brake Line install
Model : GEO, Metro Category : Brakes
... go. It is easy. I believe the bleeder is a 8mm box end wrench or socket to loosen it. It will need a squirt of WD-40 on the threads before you loosen it or it will most likely snap off. Rock the bleeder back and forth until it is free turning. Use plenty of WD-40 to clean the rust from the threads. It will turn perfect then. I ran about 12 ounces of brake fluid through my system when it was ... (more)
Posted : 3 June 2005  
 
98-2K Metro Clear Corners
Model : GEO, Metro Category : Misc
... oven for a few minutes for the rejoining of the two pieces. 8. After you remove it from the oven put a liberal application of silicon adhesive around the seal of the headlight and put the two pieces back together again. Make sure all clips are tight and the seal is uniform. Wipe away any excess silicon and let the light sit for at least 12 hours. 9. Repeat this process for the other headlight ... (more)
Posted : 3 June 2005  
 
Turbo Conversions
Model : GEO, Storm Category : Force Induction
... pressure fuel pump and sub-pump, and a rising rate fuel pressure regulator. Without the additional fuel, the engine will run too lean under the forced air charge of the turbo, and will detonate, and blow. Now you're finally to the point where you can use those manifolds mentioned earlier. You have to convert the entire induction system over. Intake manifold, exhaust manifold, air plenum, ... (more)
Posted : 24 May 2005  
 
Accel Adj. FPR Installation & Air/Fuel Tuning
Model : GEO, Storm Category : Engine
... it! * Now remove the bolt holding the return line & pull off the return line from the FPR. * Fuel will only run for a few seconds * Now remove the FPR. You may need to twist it side-to-side while pulling on it. If it still does not come off then use a medium size screwdriver and slowly pry it out. Pry it out slowly front to back of the FPR. * Once removed, fuel will only run for a few ... (more)
Posted : 24 May 2005  
 
Clutch & Transmission Replacement
Model : GEO, Storm Category : Driveterrain
... axle-shaft out of the transmission housing. Pulling from the spindle, move the assembly outward and away from the transmission. 19.Remove the large tranny mounting bolt at the front of the vehicle.(Will need 17mm wrench for this to clear manifold) 20.Remove the front two bolts retaining the crossmember under the radiator. 21.Remove the two back crossmember bolts, then remove the large tranny ... (more)
Posted : 24 May 2005  
 
Timing Belt Replacement
Model : GEO, Storm Category : Engine
... a SOHC engine then four additional bolts must be removed. 10. A quick way to loosen the large center bolt, is to place the socket on the bolt and the breaker bar on the floor forward of the engine. Now, hook up the battery; take out of gear and just TAP the starter. This WILL loosen the bolt. NOTE: make certain that the crankshaft is still on TDC with the #1 piston. If it has moved reset it ... (more)
Posted : 24 May 2005  
 
Changing the Fog Lamps
Model : GEO, Storm Category : Lights - Fog Lights
... assemblies behind the bumper. 3. Grasp the wire retainer (not the wire on the lamp itself) and squeeze it slightly while pulling it to the rear. It kinda hinges out of the way. 4. At this point the lamp assembly (glass section with a metal base and a wire about four inches long) should be loose. Pull it out of the socket. 5. Locate the connector on the electric wire. It is a ''snap'' type ... (more)
Posted : 24 May 2005  
 
Red Lights for the Speedo / Cluster
Model : GEO, Storm Category : Electrical
... to unscrew the actual speedo here. There are a couple screws on the top of it and a couple on the bottom. I don't know how many for sure as the person who previously owned this car had taken this off and there were some missing screws. Anyways, it's straight forward.Now you can pull the speedo forward a bit. You don't have to pull it out all the way. There are little black and green things in ... (more)
Posted : 24 May 2005  
 
Storm stereo wiring diagram
Model : GEO, Storm Category : Electrical - Radio
... these pages is without warranty, expressed or implied. Many of the modifications explained here may not be legal in your area, please check local laws and ordinances before attempting. Always wear safety equipment. Jump to Article #: Created By: Jason Yuhas / Chris Rhoades Category: Stereo/HiFi AudioElectrical System / Lighting Date Posted: 09-03-02 Views: 4230 Title: Storm stereo wiring ... (more)
Posted : 24 May 2005  
 
Apex-i SAFC Wiring Instructions
Model : GEO, Storm Category : Electrical
... they work well on some wires, while on others, I recommend they be soldered on If you have a Haynes manual it will come in handy in this part 5. On the instrument wiring harness, locate the RPM wire (It comes off the ignition coil and is a black with red wire) 6. Connect the GREEN wire from the SAFC to the BLACK/red wire for the Tach. (I don't remember the position of this wire on the ECU, ... (more)
Posted : 24 May 2005  
 
Check Engine Light Fault Codes and What They Mean
Model : GEO, Storm Category : Misc
... This will occur three times. After the third ''Code 12'' display the other codes will flash. Each will be displayed three times then it will move on to the next code, if any more are stored. This will continue until all codes have been displayed, then the ''code 12'' will be flashed again. Write down each code as it is displayed so as to not miss any or try to remember them. If you should ... (more)
Posted : 24 May 2005  
 
Geo Storm Idle Problems - Random Revving/Stalling
Model : GEO, Storm Category : Misc
... soaked in carb or TB cleaner, gentle clean the pointed end of the IAC. DO NOT PRESS THE VALVE INTO THE BODY OF THE IAC. This could cause the tiny motor and gear to strip ruining your IAC valve. Also, clean the area inside the TB itself. Again, liberally soak your rag with carb or TB cleaner. Using the blunt, or handle end, of a small screwdriver press rag into the TB and thoroughly clean the ... (more)
Posted : 24 May 2005  
 
Rear Spoiler to Aluminum Wing Conversion
Model : GEO, Storm Category : Exterior
... hatch glass in the corners. To fix the holes in the glass, visit your local GM dealer and purchase the corner hatch moldings for the base model Storm. These cost me $4.67 total. As for the other holes, go to your couch cushions and get a few pennies. You can tack weld these to the underside of the hatch or from the top where the holes are. After you are done, smooth them over with some ... (more)
Posted : 24 May 2005  
 
Ultimate Short Shifter
Model : GEO, Storm Category : Driveterrain
... a larger eye. Remove the pin that holds these in place. Remove the upper washer and then slide the eye off the stud. Dont lose these as you will need them for reinstall. You can now remove the actuator unit from the transmission. Using 14mm socket, remove the 4 bolts. You may need to give it a light tab to loosen the unit and then remove it. There is a paper gasket so be careful not to ruin ... (more)
Posted : 24 May 2005  
 
Rear Strut Tower Brace
Model : GEO, Storm Category : Suspension
... to be just a little bit over 38''. Mark that spot. And take the conduit to the Vice and cut it. 2. After it is cut measure in on one end of the conduit about 1.25'' and then put that section into the vice and clamp it until it is flat. 3. Repeat on the other end of the conduit. 4. Now remove the seat belt covers from the back seats. There should be 4 bolts on each side, some bolts are hidden by ... (more)
Posted : 24 May 2005  
 
Quickor Strut Tower Bar Installation
Model : GEO, Storm Category : Suspension - Strut bars
... 1) Set parking brake firmly (chock rear wheels if necessary) and open hood. 2) Remove the 3 mounting bolts from the top of the strut, also remove and save the rubber plug from the 4th hole in the strut tower at this time. 3) Jack up one side of the vehicle until the mounting bolts on that side can be pushed free of the strut tower. A little force may be required to loosen the top of the ... (more)
Posted : 24 May 2005  
 
Short Throw Shifter
Model : GEO, Storm Category : Driveterrain - Shifter Linkage
... to do is remove that slope. In the picture below you will see that I have 'purkled' th e area, this is only for illustration purposes. There are no points for neatness here folks Just get it out. ;o) Next we move to the side and do the same type of removal Then the rear corner gets a similar treatment In that last picture you should be able to see the shift rod. You should also be able to see 2 ... (more)
Posted : 24 May 2005  
 
Replacement of Speakers in the Geo Storm
Model : GEO, Storm Category : Electrical - Radio - Speakers
... speaker. Cut this circle out making sure to be careful not to stress the plexiglass. Once you have this form made, place the plexiglass disc in behind your door panel and mark the spots where the four pre-existing screws will mount the disc to the door (MAKE SURE THE LOWEST PART OF THE INTERIOR CIRCLE IS TOWARD THE BOTTOM OF THE DOOR). Drill these holes carefully with a bit that is one size ... (more)
Posted : 24 May 2005  
 
Dynamat Installation for the Geo Storm (Rear End)
Model : GEO, Storm Category : Misc
... to make reinstallation easier. Once the panels are off, clean the area thoroughly of any dirt or debris. Tuck away wires that might get in the way and disconnect the 3rd brake light so as not to melt the wiring. Next, I sanded all of the back that I could with my orbital sander (60 grit worked well). After sanding, the back was cleaned again with a damp rag and allowed to dry. Then began ... (more)
Posted : 24 May 2005  
 
Valve Cover Detailing for the Geo Storm
Model : GEO, Storm Category : Engine
... a coat of paint will stick to it (you could also order a new valve cover or search the boneyards for one, but cleaning yours up is more cost effective). Also, visit your local GM/Geo/Isuzu dealer and order a new valve cover seal (this needs to be done each time you remove the valve cover). I then brought my valve cover to a friend who sandblasted it for me, and you can usually get this ... (more)
Posted : 24 May 2005  
 
Throttle Body Upgrade for SOHC Owners
Model : GEO, Storm Category : Exhaust
... the TB or the intake, wherever it ends up. It should be in good shape, though it is recommended that you replace it. It may exhibit a high idle condition if not replaced. There is a slight difference between a GSi gasket and a base gasket in some years. Carefully line the gasket up on your GSi TB and tape it in place. Take your razor knife and trim away the extra gasket material using the TB ... (more)
Posted : 24 May 2005  
 
Rear Drum to Rear Disk Brakes Conversion
Model : GEO, Storm Category : Brakes
... can be done. Note: start with the easiest bolt to see. The back side lower is the best one in my opinion but you may be a contortionist and it doesn't matter to you? Once you get one bolt started do not tighten it. Get the other three bolts threaded on. We did notice that if you tighten the first bolt just slightly that the shield and hub are easier to align. Now that you have all four bolts ... (more)
Posted : 24 May 2005  
 
Keeping the fog lights on at all times
Model : GEO, Storm Category : Lights - Fog Lights
... Views: 3580 Title: Keeping the fog lights on at all times Article: Remove the fog light switch from the dash section. I popped the entire panel that holds all the switches. There are five wires on the back of the switch. There are three colored Yel-Grn; Red-Blu; Red-Grn located at one end of the switch and there are two at the other end colored Grn-Red and Red-Grn that go to the ... (more)
Posted : 24 May 2005  
 
Browse by title :
# | A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z
Browse by make :
A | B | C | D | E | F | G | H | I | J | M | N | P | S | T | V