Keyless Entry Replacement ('96 A4)
Model : Audi, A4 Category : Electrical
... the old system back in.) Remove the mounting bracket from the receiver; this bracket works pretty well to mount the new system after drilling a few holes. Installation is straightforward. Start by finding a physical location for both relays and the new receiver. I mounted the new receiver on the mounting bracket from the old system, and mounted the relays using existing holes on the front lip ... (more)
Posted : 7 June 2005  
 
KYB and Eibach/Suspension Techniques Install
Model : Mazda, RX, RX - 7 Base Category : Suspension
... be installed. In my case it is the only red one I have. The rest are black in color. The reason for that is that I bought the HKS (KYB AGX) kit as an open box buy for $150 since it was missing one front strut. I bought the 4th for the set at www.shox.com The HKS ones are black and the KYB's are red. The adjustments on the fronts are on the top of the strut and are accessible from under the hood ... (more)
Posted : 25 May 2005  
 
Kirk Racing Rollbar Install
Model : Mazda, RX, RX - 7 Base Category : Misc
... else that you might drill through!!! Look twice and drill once =) Once you have the holes drilled, take the 8 bolts, 4 each side, and place them through the holes. Then you want to twist on the nuts until they are finger tight. Have a buddy put a wrench on the top of the bolt so you can ratchet the nut on from the bottom of the car.bolt them in using a cross pattern like rotating your tires ... (more)
Posted : 25 May 2005  
 
Keyless Entry Installation
Model : BMW, 3 - Series (E30) 1983-93 Category : Electrical
... near the rear trunk lock to expose the wires. Also remove the plastic trim that covers the battery. I used a knife and cut away the material that was protecting the bundle of wires. As you can see, I used the knife to strip back insulation to test wires. Unfortunately the wire colors in the wiring diagram given by the vendor did not match any of the wires in my car. This may be because the ... (more)
Posted : 24 May 2005  
 
Keyless Entry at a Fraction of the Dealer Cost
Model : BMW, 3 - Series (E30) 1983-93 Category : Electrical
... about a half inch of wire from the two green wires without completely cutting the wires. Use the wire stripping tool to expose about 1 inch at the ends of the white/green, white/red, black, red, and grey wires from your keyless entry wire harness.5. Attach the white/green wire from the keyless entry wire harness to the exposed section of the green/black wire to your actuator. This is your lock ... (more)
Posted : 24 May 2005  
 
K&N Air Filter Install
Model : BMW, 3 - Series (E30) 1983-93, 318i Category : Engine
... filter. Required tool list: None! Click on the thumbnail for larger pictures. Undo the spring clips that hold the intake muffler top and bottom sections together. Take out the old air filter. Install the K&N air filter. Putting everything back together is much harder. Put the top section back in place. Snap the clips back in place. Difficulty: 1 /5 Disclaimer: I am not a professional ... (more)
Posted : 24 May 2005  
 
Keeping the fog lights on at all times
Model : GEO, Storm Category : Lights - Fog Lights
... Views: 3580 Title: Keeping the fog lights on at all times Article: Remove the fog light switch from the dash section. I popped the entire panel that holds all the switches. There are five wires on the back of the switch. There are three colored Yel-Grn; Red-Blu; Red-Grn located at one end of the switch and there are two at the other end colored Grn-Red and Red-Grn that go to the ... (more)
Posted : 24 May 2005  
 
Keyless Entry
Model : BMW, 5 - Series (E34) 1989-96 Category : Misc
... Crimestopper also makes a model 855RKE that has the positive trigger built in (other manufacturers also have them). I could have bought that and saved myself a little grief but I didn't know I needed positive trigger. Basically, when installing the system, you need to find a ground, a constant +12 volts, the lock wire and the unlock wire. If you want your locks to lock when you start your car ... (more)
Posted : 15 February 2005 Author : Russell Jones, Anthony, and others
 
Browse by title :
# | A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z
Browse by make :
A | B | C | D | E | F | G | H | I | J | M | N | P | S | T | V