Zainos Bros Wax Application
Model : Honda, Prelude Category : Misc
... and still looks wet on the paint, it's not dry yet.. You need to wait 12 hrs before applying a new coat of Zaino using this method. ZFX method. Each ZFX kit comes with a 2ml vial of accelerator mix and several 2-ounce mixing bottles. A single ZFX kit provides enough mix to accommodate a up to 16 ounces of Zaino. Pour one to two ounces of Z-2 or Z-3 into a 2-ounce mixing bottle. For each ... (more)
Posted : 19 May 2005  
 
ZEX Pressure Gauge
Model : Toyota, Celica Category : Interior
... The guage I received looks cheaply made...regardless, it still works and does the job. Installation is so simple and here we go…. One end screws into the NOS Bottle, the other end connects to the Main Nitrous line. Here is the guage attached to the nos bottle. This is how it looks fully loaded with the temperature guage and the bottle warmer... Note: The webmaster takes no responsibility ... (more)
Posted : 19 May 2005  
 
Zex Nitrous Bottle Warmer Install
Model : Toyota, Celica Category : Interior
... bottle heater. Attach the black ground wire to a ground on your car Reconnect your battery Test the heater Install the heater onto the bottle and you are done...its that simple Remember to read the manufacturor's precautions and instructions that are included with the bottle heater before you use it to verify that the everything is correct. Note: The webmaster takes no responsibility regarding ... (more)
Posted : 19 May 2005  
 
Zex Nos Kit Installation
Model : Toyota, Celica Category : Engine
... the NMU anywhere but very close to the intake. I have an Injen intake which made it very easy to mount in the position in the pictures, however a stock intake may have trouble. You can mount the NMU anywhere by simply buying longer stainless steel cables. The tube lines cost about 75 cents a foot and you will need 2 of 5' foot tubes. Once you finish mounting the NMU you are ready to go to the ... (more)
Posted : 19 May 2005  
 
Z8 Starter Kit Instructions
Model : BMW, Z - Series, Z8 Roadster Category : Electrical - Starter
... gray and green wire will be tapped into the factory BMW wiring. You can use a wire tap connector or do the following: Strip the insulation off the wire w/o harming the copper with a razor blade, (go around the wire lightly with the razor blade on both sides and then slice across to make an H, then peel off insulation to expose the wire) Then tap the new wire into the factory wire, then cover it ... (more)
Posted : 18 May 2005  
 
Z3 HID Retrofit
Model : BMW, Z - Series Category : Lights - Headlights
... and, unfortunately, trial and error. You want both headlights to look roughly the same, so any degree rotation off, will translate into a crooked beam pattern. This will not be so evident if you are using DOT xenon projectors since their cutoffs are not as razor shop as their ECE counterparts (with some exceptions e.g. S2000). After aiming it, I bolted the projector in place and shimmed it so ... (more)
Posted : 25 November 2004 Author : Ian Lam
 
Browse by title :
# | A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z
Browse by make :
A | B | C | D | E | F | G | H | I | J | M | N | P | S | T | V